JEGS Ignition Control Unit | Comparable to Mopar Orange Box | 5,000 RPM | Plugs Into All Mopar OEM and Performance Wiring Harnesses with 4 & 5 Pins
Product details
| Management number | 215276154 | Release Date | 2026/04/12 | List Price | $16.58 | Model Number | 215276154 | ||
|---|---|---|---|---|---|---|---|---|---|
| Category | |||||||||
Orange Ignition Control UnitComparable to Mopar Orange Ignition Box5,000 RPM Installation Notes:Case must be grounded. Be sure mounting location (firewall, bracket, or fender apron) is free of rust & paint (sand or wire brush as required) before mounting Ignition Control Unit. Make sure the mounting screws are tight and use Serrated-head screws or external-tooth lock washers to mount the Ignition Control Unit. Coat connector pins with silicone grease. Be sure wiring connector retaining screw is present and snug.Plugs into all Mopar OEM, JEGS, and Mopar Performance wiring harnesses, whether the harness or vehicle was designed for 4 or 5-pin Ignition Control Units. No modifications required.Use with ballast resister. Works with 2-Pin or 4-Pin ballast resistors. Use without ballast resistor will destroy the Ignition Control Unit. Use with OEM or OEM-Spec (oil filled) ignition coil. E-Frame coils are also acceptable. High Performance Coil 555-40105 is also recommended. Coils made for C-D ignitions (MSD, etc) may destroy the Ignition Control Unit. Coil Primary resistance should be no lower than 1.4OPre-startup test (recommended for vehicles that has experienced Ignition Control Failure). Connect a voltmeter between the coil positive (+) and a good ground. Turn ignition key to "run" position. Voltmeter should read between 7.0 and 9.0 volts. If higher turn ignition key off immediately and check ballast resister (resistance - too low 0.5O minimum, 1.0O recommended for most street applications), ballast wiring, shorted coil, ignition switch wiring, etc.Quick Wiring Check - Disconnect either ballast connector at idle. Engine should stall instantly.
- COMPARABLE TO Mopar orange ignition box
- CONNECTS TO ALL Mopar OEM and performance wiring harnesses with both 4 and 5 pins
- REPLACEMENT wiring harness and ballast resistor are available separately to repair or upgrade the ignition system
- HIREV 7500 CONTROL UNIT option is also available separately
- COMPATIBLE WITH OEM or aftermarket ignition coils with resistance no lower than 1.4 ohms
| UPC | 889944045991 |
|---|---|
| Model | 555-40800 |
| Brand Name | JEGS |
| Item Weight | 16 ounces |
| Part Number | 40800 |
| Manufacturer | JEGS |
| Material Type | Silicone |
| Connector Type | Screws |
| Item Dimensions | 7.4 x 4.4 x 2.8 inches |
| Included Components | Per Item Description |
| Warranty Description | 30 Days |
| Part Interchange Info | 40800 |
Bestseller ranking
Control Units
Correction of product information
If you notice any omissions or errors in the product information on this page, please use the correction request form below.
Correction Request Form